Borewell pump installation services
We select, fit, pipe and test submersible and openwell pumps, sized to your borewell and your daily demand, so you get steady water and a motor that lasts.
Pump installation is the fitting of a pump, motor, pipes and controls that lift water from your borewell or open well and deliver it to your tank or taps. A borewell only stores water underground. The pump is what brings it up.
A correctly sized and fitted pump gives steady flow, lasts longer and uses less power. A wrong one wastes electricity, burns out early or drains the bore faster than it can recharge.
The right pump depends on where your water sits and how you use it. These are the two main types we install.
Installed inside the borewell, fully under water. The motor and pump are sealed as one unit and push water up the rising pipe.
Placed at the surface beside an open well, sump or tank, drawing water in through a suction pipe. Monoblock and centrifugal models are common.
Choose how you will use the water to see our suggested pump options.
A single-phase submersible in your borewell fills the overhead tank. A monoblock pump can move water from a sump to the tank.
Four clear steps from choosing the pump to a tested, working supply.
We check bore depth, water level, yield and daily demand, then size the pump and motor.
The pump is lowered on a safety rope, with the cable secured neatly along the pipe.
Rising main, non-return valve, control panel and tank lines are connected and checked for leaks.
We run the pump and measure what it delivers before we hand it over.
A pump that starts is not always a pump that performs. We confirm each reading on site and explain the results, so you know your system is working as it should.
Litres delivered per hour at your tank.
Delivery pressure at the outlet.
Motor load kept within safe limits.
Panel switches off if water runs low.
Tell us about your borewell or open well. A technician will call within one working day to set a site visit time.